PHANTOM七不思議にも入ると言われているアップグレードキットについて、自分なりに調べた結果を書きます。所有していないため、間違っている可能性が高いので取り扱いには十分ご注意願います。
これが問題の基板です。
よくある質問として
【1】 iOSD miniは接続できますか?
→ 接続できません。iOSD miniやBTユニットはCAN-BUSで接続しますが、アップグレードキットの説明書を見る限り該当のコネクタはありません。
検証案件
1. ③にPMU-V2を接続?
→ 今のところ実践した事例はありません。
2. ⑦が実はCAN-BUS?
→ 今のところ実践した事例はありません。
3. EXPポートにCAN HUBを接続して分岐する。
→ 動作しないそうです。
Shingo Fujitaさん情報ありがとうございます。
4. 基板上から信号線を取り出す。
→ 海外で実施例がありました。
DJI Phantom 1 – Modify to have CAN Bus port.
DIGSONさんも記事を書かれています。
【2】 画像転送装置への接続は、本体基板 or HERO3 どちらがよいか?
→ ④端子から、信号をとるのが良いでしょう。キットにはケーブルも付属しているようですので、画像転送装置に接続するだけで利用できます。
3本の内訳は、
茶・GND
赤・VCC(+11V)
黄・ビデオ信号
ただし、本体を開けずにビデオ転送装置を使いたい場合は、HERO3のビデオ出力端子の利用となります。
以下H3-2D接続マニュアルから最終接続図です。
【3】 H3-2DのFirmwareの更新はどうするのですか?
→ Naza-M Assistant Softwareから更新出来るようです。
spjlj1 wrote:If you have the Phantom upgrade board (P330CB-H3-2D), here are the instructions on how to upgrade the H3-2D's firmware.
1. Connect the phantom to your computer using the lastest Naza-M assistant. (Naza-M Assistant Software v2.20). Power on the phantom.
2. On the Naza-M assistant, click on the Upgrade tab.
3. You should now see the lastest firmware for the upgrade board (P330CB-H3-2D)
4. Upgrade the P330CB-H3-2D board by clicking on the link.
5. Cycle the power on the Phantom.
6. Connect again to the Phantom with the Naza-M Assistant Software v2.20 application.
6. On the Upgrade tab, you should now see that a firmware upgrade is available for the H3-2D gimbal.
7. Upgrade the H3-2D firmware by clicking on the link.
All done.
0 件のコメント:
コメントを投稿